Wednesday, July 29, 2020

Rear Bed USB Ports and Organizer - July of 2020 ($50)

In the Serenity rear lounge/bed there was not a convenient place to plug in a phone without running the inverter. I installed a dual USB port in the rear storage compartment (under the lounge) and purchased two gap filler organizers to put between the wall and the bed on each side. I then ran a USB cord to each of the organizers so it is easy to plug in your phone and store it in the organizer.  The organizer is a good place for TV remotes and it has a cup holder that is too small to be really useful. I added one of the stick on folding drink holders to June's side of the bed.  

Gap filler/organizer

I put one of these on each side of the bed. 








USB Port

I added this USB port inside the rear storage compartment and then ran long USB cords to the small organizers on each side of the bed. 

The power came from the Macerator circuit which is plenty big enough to power these small USB ports. 








June's side of the bed with the organizer USB cable and drink holder.  









Update September 2026: 
All was good on our 2026 long trip, but during later trips, I found that our 12V DC cooler would sometimes toss out an alarm that it was getting low voltage. I had stole power for the rear plugs from an old USB install I did.  The wire for the USB ports was not sized to run a DC cooler. I rewired this with all 12 AWG wire that pulls power for both the USB ports and the DC cooler from the Macerator power source. This power source is delivered on a 10AWG wire that is fed by a 20A breaker in the panel.